
STEP 1
Pick out a space you think the decal would fit right.
Measure the wall to make sure your decal is the right size before you begin applying.

STEP 2
Clean the surface. Removing any dirt or oil from the surface
is very important. Making a clean surface will allow the decal to adhere properly.

STEP 3
With the decal face down, peel off the backing paper to expose the water-based adhesive. Be careful at this step, if the adhesive sticks to each other, you may end up damaging the entire sticker.

STEP 4
Align the decal and carefully place it in your desired location.

STEP 5
Rub the decal onto the surface well with the FREE Squeegee provided in the package.

STEP 6
Removing the transfer paper will let you see the final and full effect of the decal on your space. If a letter sticks to the transfer paper, put the transfer paper back over it and rub it a few more times.
Not Recommended Surfaces
- Pitted cement
- Raw lumber, like chip board or low-grade plywood.
- Oxidized or faded paint
- Textured plastic surfaces
- Rubber
- Rusted metals
- Oily surfaces
- Dusty surfaces, like fresh drywall